VS-1

The drilling system consists of a bracing column on which a mount is attached for guiding the drilling hammer, which is fitted with a two-wheel chassis to make handling easier. In the rear of the mount is the controller containing the main control elements.

The bracing column in the drilling system comprises a pneumatic cylinder with a double effective area in the direction of the ejection of the piston rod. On the bracing pneumatic cylinder is a movable single-acting pneumatic cylinder where the sleeve travels on a toothed comb with the console for clamping the mount.

The drilling mount consists of a series connected set of two pneumatic cylinders. The main pneumatic cylinder consists of the body of the mount where the drilling hammer travels on the upper side. The auxiliary pneumatic cylinder located on the side of the mount causes the required longitudinal movement of the mount in the drilling direction. The mount can be tilted on the console at any angle.

The control panel on the drilling system enables centralized control of all the functions. The drilling set is designed so that it can be operated by one employee.

The air supply to the bracing pneumatic cylinder is fitted with a safety back-flow valve to secure the bracing column against release in the case of an unexpected interruption to the supply of compressed air.

The recommended type of drill hammer is the VKS-29 hammer supplied by the manufacturer.

Technical data